Dash Vent Holley EFI 3.5" Screen Mount

Make sure to go through all the instructions before beginning the installation.

These instructions apply to the Dash Vent Holley EFI 3.5" Screen Mount.

1. Use an angled pick to release the lower and upper tabs on the inner passenger-side vent, then slide the vent out.
   
   
   
   
2. Once the vent is removed, slide the Dash Vent Holley EFI 3.5" Screen Mount into the opening until it stops, ensuring it’s fully seated in place.
   
   
   
   
3. Once the Dash Vent Holley EFI 3.5" Screen Mount is fully seated, slide the vent back into place until the tabs click securely.
   
   
   
   
4. To run the wire, route it under the dash pad to the passenger side A-pillar, where there’s a space to drop the cable down to the passenger kick panel.